TIP 0425-03 "Design, monitoring and maintenance guidelines for Yankee dryer bearings" (New)

T 411 om-15 "Thickness (caliper) of paper, paperboard, and combined board" (Revised)

T 456 om-15 "Tensile breaking strength of water-saturated paper and paperboard ("wet tensile strength")" (Revised)

T 480 om-15 "Specular gloss of paper and paperboard at 75 degrees" (Revised)

T 489 om-15 "Bending resistance (stiffness) of paper and paperboard (Taber-type tester in basic configuration)" (Revised)

T 509 om-15 "Hydrogen ion concentration (pH) of paper extracts (cold extraction method)" (Revised)

T 534 om-15 "Brightness of clay and other mineral pigments (d/0 diffuse)" (Revised)

T 541 om-15 "Internal bond strength of paperboard (z-direction tensile)" (Revised)

T 553 om-15 "Alkalinity of paper as calcium carbonate (alkaline reserve of paper)" (Revised)

T 566 om-15 "Bending resistance (stiffness) of paper (Taber-type tester in 0 to 10 Taber stiffness unit configuration)" (Revised)

T 567 om-15 "Determination of effective residual ink concentration (ERIC) by infrared reflectance measurement" (Revised)

T 600 om-15 "Analysis of formaldehyde in aqueous solutions and of free formaldehyde in resins" (Reaffirmed)

T 610 sp-15 "Preparation of indicators and standard solutions" (Reaffirmed)

T 808 cm-15 "Flat crush test of corrugated board (flexible beam method)" (Reclassified from Official to Classical Method)

T 829 om-15 "Score quality test" (Revised)

T 844 pm-15 "Determining construction (nominal basis weight) of corrugated board" (Revised)

T 1006 sp-15 "Testing of fiber glass mats: use of modified TAPPI procedures for sampling and lot acceptance, stiffness, tear resistance, and thickness" (Revised)

T 1011 om-15 "Basis weight of fiber glass mats" (Revised)

T 1013 om-15 "Loss on ignition of fiber glass mats" (Revised)

T 1014 om-15 "Moisture sensitivity of fiber glass mats" (Revised)

T 1016 om-15 "Average fiber diameter of fiber glass mats" (Reaffirmed)

Special note: Documents appearing in the TAPPI online version of the Standards and TIPs are updated once a month (usually around the 15th). So it is possible that there is a delay between the publication announcement and the posting online. If you are a subscriber to the online access to Standards and TIPs and you are in a hurry for new documents that have not yet been posted, you can send a request to standards@tappi.org.